Stihl Chainsaw Ignition Coil Test. Read out the correct resistance reading of your chainsaw in the user manual. The parameter can exceed 15 kω.
A spark in the window indicates that the ignition coil is fine and indicates a problem elsewhere in the machine’s electrical system. Press the ignition module (2) against the setting gauge. The sparks indicate that the ignition coil functions properly.
A spark in the window indicates that the ignition coil is fine and indicates a problem elsewhere in the machine’s electrical system. The saw is equipped with an easy start system. The test i performed was for secondary coil resistance between.
Look what it touches the core inside. Gasoline engine that runs on a mixture of fuel and oil in a ratio of 1: How to set the ignition on a chainsaw.
Immediately before adjusting, you need to check the condition of the spark plug. Disconnect the ignition coil wire from the spark plug. Equipment needed # ignition tester
I will show you how to test ignition coil with tester. Make sure the kill wire is disconnected from the coil and then test for spart by putting the spark plug in to the ht cap, earth it on the cylinder and pull the engine over fast and check for spark, if no spark is found then try a different plug. This is a smaller gap than usual but stick with it.
It is indicated in the instruction manual. To do this, you need to remove the wires from the head and carefully unscrew the part from the socket with a special key. If the light does not flash inside the tool, the ignition coil needs replacing.